EUROLITE DT-2 DMX IP T-Con cavo combinato XLR 3 poli, 1,5 m

EUROLITE DT-2 DMX IP T-Con 3-pin XLR combined cable, 1.5 m is a combined DMX signal cable with 3‑pin XLR connectors and a 1.5 meter length. It is designed for reliable DMX signal transmission in lighting setups and for use where IP-rated cabling is required. The cable supports standard 3‑pin XLR connections and is intended for indoor use and protected outdoor environments where moisture or dust protection is necessary.

Advantages

The cable offers a ready-made 1.5 m connection with pre-fitted 3‑pin XLR connectors, which simplifies installation and reduces preparation time. Its IP-rated design improves resistance to moisture and dust compared to non-IP cabling, helping maintain stable DMX transmission in less-than-ideal environments. Being a combined cable, it integrates signal conductors and connectors in a single assembly for straightforward use in lighting control chains.

Suitable for

Key specifications

How to use

Connect the 3‑pin XLR connectors to the DMX output of the controller and the DMX input of the fixture or distribution device, ensuring correct pin alignment. Route the 1.5 m cable to avoid tight bends and mechanical strain on connectors. For protected outdoor use, place connections in sheltered or protected housings where possible to maintain the IP protection and prevent direct exposure to heavy rain or prolonged immersion.

Recommendations

Inspect connectors and cable integrity before use and avoid subjecting the cable to sharp bends, heavy loads or direct water spray. Use appropriate cable management and strain relief at connector points to prolong service life and preserve reliable DMX transmission.