Filamento AnyCubic PETG nero 1 kg — filamento per stampa 3D, materiale PETG, bobina da 1 kg

AnyCubic PETG Filament Black 1 kg is a PETG spool designed for FDM/FFF 3D printers. It combines easy printing characteristics similar to PLA with mechanical strength and impact resistance closer to ABS, making it suitable for durable parts, housings and prototypes. The filament resists water, weather and many chemicals, and is supplied on a reusable spool with an identification chip for compatibility with AnyCubic ACE Pro.

Advantages

PETG offers good layer adhesion and reduced warping compared with some engineering plastics while providing high impact resistance (45 kJ/m² in the X–Y axis). The material maintains gloss and structural integrity over time, resists a range of household chemicals and can withstand elevated temperatures up to its softening point. The spool’s threaded connection reduces tangles and the identification chip enables automatic recognition of print settings on supported printers.

Suitable for

• Functional prototypes and mechanical parts
• Enclosures, housings and mounting brackets
• Outdoor components exposed to moisture and weather
• Toys and durable consumer items

When it may not be suitable

PETG is not as rigid as some engineering plastics and may not be ideal for parts that require very high heat resistance beyond its softening point (around 72°C). It can absorb moisture from the air, so prints may show defects if the filament is printed without proper drying and storage.

Key specifications

• Color: black
• Net weight: 1 kg
• Recommended nozzle diameter: 0.2 mm or larger
• Nozzle temperature: 230–250°C
• Build plate temperature: 60–70°C
• Recommended print speed: 50–250 mm/s
• Maximum material flow: 12 mm³/s
• Density: 1.23 g/cm³
• Material flow rate (melt index): 25±3 g/10 min
• Melting point: 130°C
• Softening point: 72°C
• Heat deformation temperature: 69°C
• Moisture absorption: 0.40%
• Stiffness (modulus): 1850±100 MPa
• Tensile strength (X–Y): 52±1 MPa
• Elongation at break: 13±1%
• Flexural strength: 80±2 MPa
• Impact resistance (X–Y): 45±2 kJ/m²
• Tensile strength (Z-axis): 31±3 MPa

How to use

Dry the filament before printing at 55–65°C for 8–10 hours if it has been exposed to humid conditions. Load the spool onto a compatible FDM/FFF printer, set the nozzle temperature to 230–250°C and the build plate to 60–70°C, and use a nozzle diameter of 0.2 mm or larger. Adjust print speed within the 50–250 mm/s range and configure cooling and retraction settings according to your printer and model to minimise stringing and ensure good layer adhesion.

What to consider before purchase

• Confirm printer compatibility with PETG and spool dimensions
• Plan for filament drying and controlled storage to prevent moisture uptake
• Ensure your nozzle and bed can reach the recommended temperatures
• Check whether automatic profile recognition (ACE Pro) is required for your workflow

Recommendations

For best results, store the spool in a dry container or desiccant box when not in use and pre-dry before printing. Start with middle-range nozzle temperatures and moderate speeds, then fine-tune cooling and retraction to reduce stringing while preserving layer adhesion.