Kit ventole per case Montech GF120 PWM ARGB 3-in-1 — ventole PWM da 120 mm con illuminazione ARGB

The Montech GF120 PWM ARGB 3-in-1 pack contains three 120 mm case fans with PWM speed control and addressable RGB lighting. These fans are intended for PC cooling applications where adjustable airflow and configurable lighting are required. Each fan combines a standard 120 mm form factor with hub-mounted ARGB LEDs and a PWM-compatible motor, allowing speed regulation through a compatible motherboard header or a separate PWM controller.

Advantages

These 120 mm PWM ARGB fans offer a balance of cooling performance and visual customization. PWM control enables automatic fan speed adjustment based on system temperature, reducing noise during low load and increasing airflow under heavy load. Addressable RGB lighting provides per-led lighting patterns and color customization when connected to an ARGB header or controller. The three-fan pack simplifies installation for cases that require multiple intake or exhaust fans and ensures consistent airflow and lighting across matched units.

Suitable for

• Gaming desktop builds requiring improved case airflow
• Workstation PCs where temperature-dependent fan control is preferred
• Systems with ARGB support for synchronized lighting effects
• Upgrading or replacing multiple 120 mm case fans at once

Key specifications

• Fan size: 120 mm diameter
• Control type: PWM (pulse-width modulation) for speed regulation
• Lighting: Addressable RGB (ARGB) LEDs integrated in the fan hub
• Pack quantity: three fans per set
• Mounting: standard 4-hole 120 mm case mounting pattern
• Connector types: PWM power connector and ARGB signal connector (compatible with standard 3-pin ARGB headers)

How to use

Install each fan in the desired case location using the 4 mounting screws provided by the case or compatible screws. Connect the PWM power connector to a motherboard fan header labeled PWM or to a PWM-capable fan controller. Connect the ARGB signal cable to a motherboard ARGB header or an external ARGB controller to enable lighting control. Configure fan curves and ARGB effects in the motherboard firmware or in the controller software to match thermal and aesthetic preferences. Ensure cable routing does not obstruct other components or airflow paths.

Recommendations

For optimal thermal performance, use a front-to-back airflow layout: position one or more fans as intake at the front and one or more as exhaust at the rear or top. Set PWM fan curves to increase speed around typical CPU or GPU temperature thresholds to balance noise and cooling. When connecting ARGB, verify header pinouts and voltage compatibility before plugging to avoid LED damage.