Microconnect SFTP702R Cavo di rete rosso 2 m Cat7 S/FTP (S-STP)

The MicroConnect SFTP702R is a 2 m red networking cable built to Cat7 standard with S/FTP shielding and RJ-45 connectors on both ends. It provides a reliable wired connection between network devices such as switches, modems, routers or to structured infrastructure via patch panels, keystone jacks or wall outlets. The cable is commonly used in small office, home networks and entertainment setups and is backwards compatible with Cat6a, Cat6, Cat5e and Cat5.

Advantages

SFTP shielding reduces electromagnetic interference (EMI) and minimizes crosstalk, helping maintain signal integrity and stable data transmission. The cable is tested to Cat7 frequencies (up to 600 MHz) while using Cat6a-compatible RJ-45 connectors for broad device compatibility. A molded snagless boot protects the connector latch during installation in confined spaces. The 2 m length and red colour allow easy identification and flexible placement in wiring layouts.

Suitable for

• Connecting routers, switches and modems to each other or to patch panels
• Small office and home network cabling
• Wired connections for media players, smart TVs and networked game consoles
• Environments where EMI protection and reduced crosstalk are important

Key specifications

• Standard: Cat7 (S/FTP shielding)
• Tested frequency: up to 600 MHz
• Length: 2 m
• Connectors: RJ-45 to RJ-45
• Colour: Red
• Weight: 0.07 kg
• Compatibility: backward compatible with Cat6a, Cat6, Cat5e, Cat5

How to use

Plug one RJ-45 connector into the network port of your device (router, switch, modem, PC or media player) and the other connector into the destination port such as another device, patch panel or wall outlet. Ensure connectors click into place and avoid bending the cable sharply near the ends. Route the cable to prevent strain or kinks and secure with cable ties or clips where necessary.

Recommendations

For best performance, avoid running the cable parallel and close to power lines or other sources of strong electromagnetic interference; use twisted paths or separate conduits where practical. Do not exceed recommended bend radius and avoid tight pulls during installation to preserve shielding and connector integrity.