Modulo ricetrasmettitore in fibra ottica BlueOptics RDH10270/2-20-BO 10000 Mbit/s SFP+

The BlueOptics RDH10270/2-20-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s optical networking. It supports single-mode fiber connections with an LC simplex connector and is intended for use in networking equipment that accepts SFP+ modules. The module is finished in silver, weighs approximately 20 g, and meets CE, RoHS and FCC compliance requirements. It provides a compact interface for high-speed data transfer in switches, routers and other compatible hardware.

Advantages

The transceiver offers a standardized SFP+ form factor that conforms to MSA guidelines, enabling broad compatibility with equipment that supports the SFP+ interface. Its 10 000 Mbit/s maximum data transfer rate supports high-bandwidth Ethernet and related protocols. The module’s compact, lightweight design simplifies installation and replacement in network racks and systems while regulatory certifications ensure adherence to common safety and environmental standards.

Suitable for

Key specifications

How to use

Install the BlueOptics RDH10270/2-20-BO into an SFP+ port of compatible network equipment following the equipment manufacturer’s hot-swap and electrostatic discharge precautions. Connect an appropriate LC simplex single-mode patch cable to the module’s optical interface and ensure the opposite end is connected to the matching transceiver or patch panel. Verify link status and speed on the host device and confirm that any required firmware or vendor compatibility settings are enabled on the network hardware.

Recommendations

Use single-mode LC simplex patch cords and ensure connectors are clean before mating. Confirm that the host equipment supports SFP+ modules and the required 10G protocols. If the host supports digital diagnostics (DDM/DOM), enable and monitor the available parameters to assist with remote diagnostics and link maintenance.