Modulo ricetrasmettitore in fibra ottica BlueOptics SFP-XG-LX-SM1310-CM-BO SFP+ LC alluminio 20g

The BlueOptics SFP-XG-LX-SM1310-CM-BO is a 10G SFP+ fiber optic transceiver module designed for single-mode, long-distance data transmission. It uses an LC duplex connector and an aluminium housing, combining compact dimensions and a lightweight design (approx. 20 g) for installation in switches, routers and other network equipment that support SFP+ modules. The module supports 10 Gigabit Ethernet transmission over single-mode fiber with a typical maximum reach of up to 10,000 metres and conforms to MSA form-factor and optical parameters for 10GBASE-LR operation.

Advantages

This transceiver provides stable 10 Gigabit connectivity over long distances while being compatible with MSA-compliant SFP+ ports. The aluminium housing offers a durable, lightweight solution for dense installations and helps with heat dissipation. Integrated transmitter and receiver optics at 1310 nm enable simultaneous send/receive operation via LC duplex fibre. The module includes digital diagnostics monitoring (DDM/DOM) support for remote monitoring of supply voltage, laser bias current, transmit power, receive power and temperature when the host device supports this feature.

Suitable for

Key specifications

How to use

Insert the module into a compatible SFP+ port on the powered-off or hot-swappable host following the hardware vendor’s instructions. Connect LC duplex single-mode patch cords to the transmit and receive ports using proper polarity (Tx to Rx). Verify link status on the host device and consult the device interface for DDM/DOM values if remote diagnostics are required. When removing the module, use the ejector mechanism provided by the host port and handle the optical interfaces with dust caps or cleaning procedures to avoid contamination.

Recommendations

The module is intended for use in equipment that supports MSA-compliant SFP+ transceivers and DDM/DOM functionality. Use single-mode LC patch cords and maintain clean fibre connectors to ensure optimal signal quality. Confirm vendor compatibility for the host device and update firmware if required to enable full functionality and diagnostic reporting.