Modulo ricetrasmettitore in fibra ottica BlueOptics UACC-OM-MM-10G-D-2-BO SFP+ LC

The BlueOptics UACC-OM-MM-10G-D-2-BO is a fiber optic SFP+ transceiver module designed for 10G optical links over multi-mode fiber. It uses an LC duplex connector and a compact aluminum housing, weighing approximately 20 g. The module implements the SFP+ interface and is intended for use in networking equipment that supports SFP+ transceivers for high-speed data transmission.

Advantages

The module provides a standardized SFP+ form factor that fits into a wide range of compatible network switches, routers and optical devices. Its aluminum case offers a durable, lightweight solution for rack or chassis installations. Built to MSA-compatible mechanical and electrical specifications, this transceiver supports reliable optical signal transmission and straightforward hot-swap replacement in active systems.

Suitable for

Key specifications

How to use

Insert the transceiver into an SFP+ slot on a compatible networking device until it clicks into place, then connect LC duplex fiber patch cords to the transmit and receive ports. Ensure the host device supports SFP+ modules and that the fiber type and patch cords match the module specification (multi-mode). Perform link tests after installation to verify signal integrity and proper operation.

Recommendations

For optimal performance, use high-quality multi-mode LC patch cords and follow the host equipment vendor’s guidelines for supported transceivers. Keep the transceiver dust caps on when not in use, and avoid excessive bending of fiber cables near the connector. Verify compatibility with the target hardware and enable any diagnostic monitoring features the host device provides for remote status checks.