Modulo ricetrasmettitore in rame BlueOptics 0XTY28-BO 1250 Mbit/s RJ-45

The BlueOptics 0XTY28-BO is a copper SFP transceiver module with an RJ-45 interface and a maximum data transfer rate of 1250 Mbit/s. Designed in a compact SFP form factor and weighing approximately 20 g, this module provides a standardized physical connection for network devices that accept SFP copper modules. The product colour is silver and it supports link distances up to 100 m when used over compatible copper cabling. The module is intended for integration into switches, routers, storage systems and other network hardware that accept SFP copper interfaces.

Advantages

The transceiver offers a compact SFP form factor that conserves space in network chassis and enables hot-swappable installation where supported. With a rated mean time between failures (MTBF) of 3,000,000 hours, the module is specified for long-term operation and reduced replacement frequency. The RJ-45 copper interface delivers compatibility with standard Ethernet cabling for straightforward connection and maintenance.

Suitable for

• Connecting network ports on switches and routers to copper Ethernet cabling (up to 100 m)
• Replacing or extending SFP-based server and storage interfaces that accept copper SFP modules
• Integrating into hardware platforms that require a 1000BASE-T RJ-45 SFP form factor

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance over copper: 100 m
• Form factor: SFP (small form-factor pluggable)
• Interface: RJ-45 (copper Ethernet)
• Weight: 0.02 kg
• Product colour: Silver
• Rated reliability (MTBF): 3,000,000 hours

How to use

Install the BlueOptics 0XTY28-BO by inserting the SFP module into a compatible SFP cage on the network device while the device is powered down or, if the platform supports hot-swap, while powered on according to the device vendor’s guidance. Connect a standard RJ-45 twisted-pair copper cable to the module to establish a 1000BASE-T Ethernet link. Verify link status and network configuration using the host device’s management interface and adjust speed/duplex settings if required by the network environment.

Recommendations

Use shielded or unshielded Cat5e/Cat6/Cat6A cables appropriate for the desired link quality and follow the host device vendor’s compatibility list to ensure predictable operation. Ensure firmware and driver support on the target hardware and perform link tests after installation to confirm full connectivity up to the specified 100 m range.