Modulo ricetrasmettitore SFP+ BlueOptics 02310CRM-BO 10000 Mbit/s 1310 nm

The BlueOptics 02310CRM-BO SFP+ transceiver module is a fiber-optic 10GBase-LRM compliant device designed for high-speed data transmission at up to 10000 Mbit/s. Operating at a wavelength of 1310 nm with LC Duplex connectivity, this compact module supports multimode fiber links and is RoHS compliant. Its lightweight metal housing in silver and black and an MTBF of approximately 1,000,000 hours make it suitable for a range of networking installations requiring reliable 10 Gbps links.

Advantages

The module provides 10 Gbit/s optical connectivity in a small SFP+ form factor that fits MSA-compliant ports. It supports simultaneous transmit and receive over LC Duplex connections and is suitable for multimode fiber runs up to the LRM reach. Built with high-quality optical and electronic components, the transceiver offers long operational life and stable signal transfer while being compatible with common enterprise and carrier-class hardware platforms that accept SFP+ 10GBase-LRM modules.

Suitable for

• 10 Gbps uplinks between switches and routers in data center and campus networks
• Server-to-switch connections requiring SFP+ ports
• Storage and SAN interconnects using multimode fiber
• Network equipment replacements or compatibility upgrades for 10GBase-LRM ports

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm
• Connector: LC Duplex
• Target fiber type: Multimode fiber (LRM reach)
• Typical reach: up to LRM specified distances on multimode fiber (industry-standard LRM range)
• Compliance: RoHS
• Weight: 20 g

How to use

Insert the BlueOptics SFP+ transceiver into an MSA-compliant SFP+ slot on a switch, router or storage device while the host port is powered off or following the device manufacturer's hot-plug guidelines. Connect LC Duplex multimode fiber patch cords ensuring correct transmit/receive orientation. Verify link status on the host device and, if available, enable or check digital diagnostic monitoring (DDM/DOM) through the equipment management interface to monitor voltage, temperature and optical power parameters.

Recommendations

Use verified multimode LC Duplex fiber patch cords and follow the host vendor's compatibility list or testing procedure when deploying this transceiver. If DDM/DOM monitoring is required, confirm the host equipment supports the diagnostics feature. For best results, perform end-to-end testing of optical power and link integrity after installation and keep connectors clean to maintain signal quality.