Modulo ricetrasmettitore SFP+ BlueOptics 0WTRD1-BO LC alluminio 20g

The BlueOptics 0WTRD1-BO is a high-performance SFP+ transceiver module designed for short-range multimode fiber links. It features an LC duplex connector and an aluminium housing, weighing approximately 20 g. The module supports 10G optical transmission for integration into compatible network equipment that accepts SFP+ pluggable transceivers.

Advantages

This SFP+ transceiver follows MSA form-factor conventions and provides a compact, lightweight aluminium design suitable for dense installations. Its LC connector and SFP+ interface enable straightforward insertion into SFP+ ports. Built to work with standard 10G multimode links, the module is intended for consistent optical data transmission while minimizing electromagnetic susceptibility characteristic of fiber connections.

Suitable for

• Short-range 10 Gigabit Ethernet links over multimode fiber
• Installation in switches, routers and storage systems with SFP+ ports
• Data center patching and aggregation panels using LC duplex connectors

Key specifications

• Interface type: SFP+
• Connector: LC duplex
• Housing material: aluminium
• Weight: approx. 0.02 kg
• Optical medium: multimode fiber (short-range)
• Nominal data rate: 10 Gbps

How to use

Power down or follow hot-swap procedures recommended by your equipment vendor, then insert the SFP+ transceiver into the host device's SFP+ slot until it seats securely. Connect LC duplex multimode fiber patch cords to the module, observing correct TX/RX orientation. Verify link status and, if required, confirm module detection and operational parameters in the host device management interface. Follow the switch or router manufacturer's guidance when enabling diagnostic features or adjusting interface settings.

Recommendations

Use compatible multimode fiber patch cords and ensure the host device supports SFP+ transceivers of this type. Observe electrostatic discharge (ESD) precautions when handling the module, keep protective caps on connectors when not in use, and follow the equipment vendor's hot-swap and module compatibility guidelines to maintain reliable operation.