Modulo ricetrasmettitore SFP BlueOptics ER-1002-0-BO 1250 Mbit/s LC

The BlueOptics ER-1002-0-BO is an SFP transceiver module for single‑mode fiber networks, supporting a maximum data transfer rate of 1250 Mbit/s and using an LC duplex optical interface. The compact, silver-coloured module weighs approximately 20 g and is designed to meet CE, RoHS and FCC compliance requirements. It implements 1000BASE-LX optical transmission characteristics with 1310 nm transmitter and receiver wavelengths suitable for links up to several kilometers when used with single‑mode fiber.

Advantages

The module follows MSA-compatible SFP form-factor standards, enabling straightforward plug-and-play installation in equipment with compatible SFP slots. Built to industry interoperability criteria, it supports Ethernet and other high-speed protocols up to 1.25 Gbit/s while offering a small footprint and low weight for space-constrained network devices. Compliance with CE, RoHS and FCC standards reflects regulatory and environmental conformity.

Suitable for

Key specifications

How to use

Insert the BlueOptics ER-1002-0-BO into a vacant SFP slot on a compatible switch, router or network appliance while the device is powered off or following the vendor’s hot‑swap instructions. Connect an LC duplex single‑mode fiber patch cable to the module’s LC connector, ensuring correct transmit/receive alignment. Configure the host device’s interface settings according to the network requirements and verify link status. If supported by the host, enable or query digital diagnostics functions to monitor optical parameters.

Recommendations

Use high-quality single‑mode LC patch cords and ensure the remote transceiver supports 1000BASE-LX to achieve expected reach and performance. Verify that the host hardware firmware and drivers accept MSA-compatible transceivers and enable digital diagnostics (DDM/DOM) if monitoring of optical parameters is required.