Modulo ricetrasmettitore SFP BlueOptics SFP-10G-BXD-20-BO 10000 Mbit/s 1330 nm

The BlueOptics SFP-10G-BXD-20-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s links using 1330 nm wavelength transmission. It uses an LC simplex connector in an SFP+ form factor and is intended for use in standard network hardware that accepts SFP+ optical modules. The module supports simultaneous transmit and receive operation over single-fiber links using wavelength-division duplexing, and includes digital diagnostics for real-time monitoring of key optical and electrical parameters.

Advantages

This SFP+ transceiver combines a compact SFP+ form factor with a 10 Gbit/s maximum data rate, low weight and long mean time between failures to deliver reliable optical connectivity. Compliance with MSA mechanical and electrical standards ensures broad compatibility with common switches, routers and storage systems. Integrated digital diagnostics (DDM/DOM) provide live information on supply voltage, laser current, optical transmit and receive power and temperature to support maintenance and monitoring.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-10G-BXD-20-BO into an SFP+ slot of a compatible network device following the device manufacturer’s insertion and extraction procedures. Connect an LC simplex fiber patch cable to the module and to the opposing transceiver, observing correct fiber polarity and the single-fiber wavelength assignments. Ensure the host device supports 10GBASE-BX-D operation and, if required, verify that DDM/DOM functions are enabled on the host to access diagnostic information. After installation, confirm link status and monitor optical power and temperature values to validate proper operation.

Recommendations

Use approved LC simplex single-fiber patch cables sized for 10 Gbit/s operation and verify compatibility with the target hardware platform. Maintain clean fiber endfaces, avoid sharp bends in fiber runs, and keep the transceiver within the operating temperature range specified by the host device. Enable DDM/DOM monitoring in the network management system when available to assist with troubleshooting and preventive maintenance.