Modulo ricetrasmettitore SFP BlueOptics SFP-3-CM-BO 155 Mbit/s 1310 nm

The BlueOptics SFP-3-CM-BO 155 Mbit/s 1310 nm is a fiber optic SFP transceiver module designed for single-mode links. It supports a maximum data transfer rate of 155 Mbit/s at a wavelength of 1310 nm and uses an LC duplex optical interface. The module is built to MSA form-factor standards, has a silver housing, weighs approximately 20 g and offers a high mean time between failures (MTBF) for extended operational life. It is suitable for use in switches, routers and other networking hardware that accept SFP modules and support 100BASE-LX or similar optical protocols.

Advantages

The transceiver provides a standardized SFP interface and compatibility with devices that support 100BASE-LX or equivalent single-mode optical links, enabling straightforward integration into existing network equipment. With a 1310 nm transmitter and receiver it supports reliable optical transmission over extended distances typical for single-mode fiber. The product's high MTBF and metal housing contribute to long-term availability and stable performance in continuous operation environments.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures for your host device according to the manufacturer's instructions, then insert the BlueOptics SFP-3-CM-BO into an available SFP slot until it seats firmly. Connect LC duplex single-mode fiber patch cords to the module, observing correct transmit/receive orientation. Ensure the host device is configured for the intended optical interface and protocol (for example 100BASE-LX or compatible settings). If Digital Diagnostics Monitoring (DDM/DOM) is supported by your host hardware, enable and monitor the live parameters to verify link health.

Recommendations

Use high-quality single-mode LC duplex patch cords and ensure fiber connectors are clean before mating. Verify host compatibility with 100BASE-LX or equivalent optical protocols and confirm DDM/DOM support if remote diagnostics are required. Follow electrostatic discharge (ESD) precautions when handling the module and avoid bending fiber beyond recommended radius to maintain link performance.