Modulo ricetrasmettitore SFP BlueOptics TEG-MGBS40D3 1250 Mbit/s

The BlueOptics TEG-MGBS40D3 1250 Mbit/s SFP transceiver module is a compact fiber optic interface designed to integrate into SFP-compatible network equipment. It provides a single-channel optical link suitable for short- to medium-distance fiber connections and supports a data transfer rate up to 1250 Mbit/s. The module is intended for use in switches, routers and media converters that accept SFP form-factor transceivers and follows standard electrical and optical signaling for straightforward interoperability.

Advantages

This SFP transceiver offers a standardized SFP interface for hot-pluggable installation, enabling simple replacement or upgrades without powering down host devices. With support for 1250 Mbit/s throughput, the module delivers reliable single-channel optical transmission for Ethernet and legacy serial fiber links. Its compact SFP form factor and conformity with common optical signaling make it suitable for mixed-vendor environments and flexible network deployment.

Suitable for

• Connecting switches and routers over fiber where SFP ports are available
• Extending network segments in data centers and server rooms
• Replacing or upgrading existing SFP transceivers in enterprise networks
• Use in media converters and fiber extension equipment

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Form factor: hot-pluggable single-channel optical transceiver
• Application: fiber optic point-to-point links for Ethernet and similar protocols

How to use

Insert the BlueOptics SFP transceiver carefully into an empty SFP slot of a compatible network device until it clicks into place. Connect an appropriate fiber optic cable to the transceiver’s optical port, ensuring correct connector type and fiber polarity. After physical installation, verify link status through the host device’s management interface and configure port settings as required for the network protocol and speed. To remove the module, follow the device manufacturer’s hot-swap instructions and handle the optical connectors with dust caps when disconnected.

Recommendations

Use clean, compatible fiber patch cords and observe ESD precautions during installation. Verify that the host device supports SFP transceivers at 1250 Mbit/s and check link diagnostics after installation to confirm signal integrity and correct configuration.