Modulo ricetrasmettitore SFP+ BlueOptics TN-SFP-10G-LR-BO 10G 1310nm

The BlueOptics TN-SFP-10G-LR-BO is an SFP+ fiber optic transceiver module designed for 10GBASE-LR links. It supports 10 Gbit/s data rates over single-mode fiber at a wavelength of 1310 nm and is specified for reach up to 10 km. The module uses an LC duplex interface, features a metal housing for mechanical robustness and electromagnetic shielding, and operates from a 3.3 V supply while weighing approximately 3 g. The transceiver is compatible with equipment that accepts standard MSA SFP+ modules and implements digital diagnostics monitoring for real-time status information.

Advantages

The BlueOptics 10G SFP+ module offers high-speed 10G transmission with low latency over long single-mode fiber spans. Its metal casing provides durability and improved heat dissipation. Built to industry MSA standards, the module is interoperable with a wide range of switches, routers and storage systems. Integrated digital diagnostics (DDM/DOM) enables remote monitoring of supply voltage, laser bias current, transmit power, receive power and module temperature to simplify maintenance and troubleshooting.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ slot on a compatible switch, router or network interface card until it clicks into place, then connect LC duplex single-mode fiber patch cords, observing correct transmit/receive orientation. Ensure the host device supports SFP+ modules and any vendor compatibility requirements. Power the system normally; the module draws 3.3 V from the host. Use the host management interface or SNMP monitoring to read DDM/DOM parameters if supported by the equipment. When removing the module, power down the port if required by the host, gently press the release latch and extract the transceiver to avoid damage.

Recommendations

For optimal performance, use single-mode LC duplex fiber and quality patch cords with appropriate connectors, keep transceiver dust caps in place when not connected, and verify that the host device supports DDM/DOM if remote diagnostics are needed. Avoid exceeding the specified operating temperature range and follow ESD precautions when handling the module.