Modulo transceiver in fibra ottica BlueOptics 10303-BO 10000 Mbit/s SFP+

The BlueOptics 10303-BO is a fiber optic transceiver module in an SFP+ form factor designed for 10 Gbit/s network links. Its compact silver housing and SFP+ interface enable simple hot-pluggable installation into compatible switches, routers and network interface cards. The module is intended for high-speed optical connections where a small, standardized transceiver with a 10000 Mbit/s maximum data transfer rate and long operational life is required.

Advantages

The BlueOptics 10303-BO offers a standardized SFP+ interface for broad compatibility and straightforward replacement. With a rated maximum data transfer rate of 10000 Mbit/s, it supports demanding bandwidth requirements for data center, server and telecom environments. The module’s compact silver housing minimizes space use in dense rack deployments, while the specified MTBF of 1,000,000 hours indicates an expected long service life. Compliance with CE, FCC and RoHS standards ensures regulatory conformity and reduced environmental impact.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and servers
• High-speed connections in data centers and server rooms
• Fiber links for telecom and carrier equipment with SFP+ ports
• Network interface card (NIC) upgrades requiring SFP+ optical modules

Key specifications

• Form factor: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Interface type: Fiber optic SFP+
• Product colour: Silver
• Weight: 0.02 kg
• MTBF: 1,000,000 hours (mean time between failures)
• Standards compliance: CE, FCC, RoHS

How to use

Power down the host port or follow the equipment vendor’s hot-swap instructions, then insert the BlueOptics 10303-BO transceiver into a compatible SFP+ slot until it clicks into place. Connect the appropriate fiber optic cable and ensure correct connector type and polarity. After insertion, verify link status and speed on the host device and confirm successful negotiation at 10 Gbit/s. To remove the module, follow the host device procedure for safe removal and extract the transceiver by the housing, taking care to protect the fiber connectors from contamination.

Recommendations

Use factory-cleaned fiber patch cords and dust caps when the transceiver is idle. Confirm compatibility with your switch or NIC vendor for optical specifications and supported link modes. Store unused modules in anti-static packaging and avoid touching connector endfaces to maintain signal integrity and prolong service life.