Modulo transceiver SFP BlueOptics SFPP-10GBASESR-BO 10000 Mbit/s 850 nm

The BlueOptics SFPP-10GBASESR-BO is an SFP optical transceiver module designed for multi-mode fiber links with a data rate up to 10 000 Mbit/s and an operating wavelength of 850 nm. The module uses an LC duplex connector and is intended for short-reach 10GBASE-SR Ethernet and other high-speed protocols. The compact silver module weighs approximately 20 g and is built to MSA-compliant mechanical and optical specifications to fit into SFP/SFP+ ports that accept 10GBASE-SR SFP+ transceivers.

Advantages

The transceiver provides a standardized SFP form factor and LC duplex interface for straightforward installation in compatible network equipment. Operating at 850 nm on multi-mode fiber, it supports high-bandwidth, low-latency links up to 300 m depending on fiber type and network conditions. The module’s tested components and design aim for long operational life and a high MTBF, reducing maintenance frequency in data center and enterprise networks.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFPP-10GBASESR-BO into a compatible SFP/SFP+ slot on the network device while the host is powered or powered down according to the device manufacturer’s guidance. Connect LC duplex fiber patch cords to the transceiver ports, ensuring correct transmit/receive alignment and proper fiber type (multi-mode). Verify link status and speed on the host hardware; if DDM/DOM is required, confirm that the host supports diagnostic access. Follow standard ESD precautions when handling the module and keep protective caps on the optical ports when not connected.

Recommendations

For reliable 10GBASE-SR performance use high-quality OM3 or OM4 multi-mode fiber and matched LC duplex patch cords. Ensure host device firmware supports third-party SFP/SFP+ modules and enable DDM/DOM in the management interface if diagnostics are needed. Store the module in a dry, dust-free environment and avoid touching the optical surfaces to maintain signal integrity.