Ricetrasmettitore SFP BlueOptics 5410-027-BO 1250 Mbit/s fibra ottica

The BlueOptics 5410-027-BO is an SFP fiber optic transceiver designed for 1.25 Gigabit Ethernet links with a maximum data transfer rate of 1250 Mbit/s. Housed in a compact SFP form factor and finished in silver, this module supports single‑mode transmission with LC connector compatibility and a maximum transfer distance of up to 80,000 m. With a mean time between failures (MTBF) of 1,000,000 hours and a lightweight construction of approximately 20 g, it is intended for use in network switches, media converters and other optical link endpoints that require a standardized hot‑pluggable interface.

Advantages

The transceiver combines a standard SFP form factor with LC fiber connectivity to ensure broad compatibility with networking equipment. Its 1250 Mbit/s throughput supports typical Gigabit optical links while the long maximum transfer distance enables extensive single‑mode runs. The modest weight and silver finish simplify handling and installation, and the high MTBF value reflects design focus on continuous operation and reliability in critical network environments.

Suitable for

• Extending Ethernet networks over single‑mode fiber between buildings or campus sites
• Use in switches, routers or media converters requiring an SFP module with LC connector
• Replacing or upgrading existing SFP ports to support 1.25 Gbit/s optical links

Key specifications

• Form factor: SFP (hot‑pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Ethernet interface: 1.25 Gigabit Ethernet
• Fiber connector type: LC
• Maximum transfer distance: up to 80,000 m (single‑mode)
• Colour: Silver
• Weight: approx. 0.02 kg
• Reliability: MTBF approx. 1,000,000 hours

How to use

Ensure the host device supports SFP modules and that the interface is compatible with 1.25 Gigabit optical transceivers. With the network equipment powered down or following the vendor's hot‑swap procedure, insert the BlueOptics 5410‑027‑BO into an empty SFP slot until it seats securely. Connect a single‑mode fiber cable with LC connectors, observing correct polarity. Configure the host interface as required by your network (speed, duplex, or auto‑negotiation settings) and perform link tests to verify connectivity. Follow standard electrostatic discharge (ESD) precautions when handling the module and protect unused ports with dust caps.

Recommendations

Use on single‑mode fiber links for maximum distance and ensure compatibility with the host equipment's supported SFP types; verify optical budgets and any vendor interoperability notes before deployment. Store and handle the module in a dry, static‑protected environment and replace dust caps when ports are unused to prevent contamination.