Ricetrasmettitore SFP BlueOptics AT-SPSX-BO 1250 Mbit/s 850 nm argento

The BlueOptics AT-SPSX-BO 1250 Mbit/s 850 nm Silver is a small form-factor pluggable (SFP) transceiver module intended for short-range multimode fiber links. It supports a maximum data rate of 1250 Mbit/s and transmits at an 850 nm wavelength. The module follows common SFP dimensions and electrical interfaces, weighs approximately 20 g, and is designed for deployment in switches, routers and other networking equipment that accept SFP modules. Compliance with CE, FCC and RoHS indicates conformity with common regulatory and environmental requirements.

Advantages

The module provides a compact SFP form factor that enables hot-pluggable installation in compatible ports and reduces space requirements in network racks and devices. With a data transfer capability of up to 1250 Mbit/s and operation at 850 nm, it is suitable for typical short-range multimode fiber connections. A high mean time between failures (MTBF) contributes to long-term reliability, while the silver casing and standard interface simplify integration with existing infrastructure.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP port on compatible network equipment following the device manufacturer’s instructions for electrostatic discharge (ESD) protection and handling. Ensure the transmit and receive fiber connectors are properly seated and matched to the multimode fiber type in use. After insertion, verify link status on the host device and configure port settings such as speed and duplex if required. Remove protective dust caps from fiber connectors before connecting and replace caps when the module is unused.

Recommendations

Use the BlueOptics AT-SPSX-BO with multimode patch cords and within the recommended short-range distance for 850 nm transceivers. Avoid exposing the module to excessive mechanical stress, moisture, or temperatures beyond the host equipment’s specifications. For interoperability, verify compatibility with the target switch or router vendor and, when possible, test in a non-critical port before full deployment.