Ricetrasmettitore SFP+ BlueOptics BO35J13610D 10GBASE-LR 10 km

The SFP+ Transceiver BlueOptics BO35J13610D 10GBASE-LR is a hot-pluggable single‑mode optical module designed for 10 Gigabit Ethernet links up to 10 km. It uses a standard LC interface and is intended for installation in compatible SFP+ ports on switches, routers and optical equipment to extend network reach over single‑mode fiber. The module supports 10GBASE-LR signaling and is suitable for long-distance fiber runs where stable, low-latency 10 Gbps connectivity is required.

Advantages

This transceiver offers hot-pluggable installation for minimal downtime and straightforward replacement. Its single‑mode design supports long-distance links up to 10 km, enabling backbone and inter-site connections. The standard LC connector and SFP+ form factor ensure broad compatibility with modern networking hardware, while the compact module conserves port density in rack equipment.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on the network device until it clicks into place. Connect single‑mode LC duplex fiber patch cables to the module, observing correct transmit/receive orientation. Configure the connected devices as required for 10 Gbps operation and verify link status through the device management interface or indicator LEDs. For hot‑swap replacement, remove the module while the device supports hot‑plug removal, and insert the replacement module following the same steps.

Recommendations

Ensure that connected network equipment supports 10GBASE-LR SFP+ modules and single‑mode fiber. Use low-loss LC connectors and maintain clean fiber endfaces to avoid signal degradation. Verify fiber polarity and perform link tests after installation to confirm expected throughput and link stability.