Set ventole radiatore 360mm ARGB PWM Jonsbo ZA-360 (nero)

Jonsbo ZA-360 is a 360mm ARGB PWM radiator fan kit in black designed for PC cooling. The kit contains three PWM-controlled fans with addressable RGB lighting in a 360mm arrangement suitable for mounting on compatible radiators or in cases that accept a 360mm fan configuration. These fans provide variable speed control for balancing airflow and noise, and include ARGB illumination to integrate with motherboard software or standard ARGB controllers.

Advantages

The ZA-360 kit combines PWM speed control and ARGB lighting in a compact 360mm format for radiator or case installation. PWM control enables automatic speed adjustment based on system temperature, helping to reduce acoustic output at low load while delivering higher airflow when cooling demand increases. Addressable RGB allows individual LED effects and synchronization with supported controllers for a coordinated system appearance. The three-fan layout ensures even airflow distribution across a 360mm radiator, improving thermal transfer compared with single-fan solutions.

Suitable for

• 360mm liquid cooling radiators requiring three 120mm fans
• PC cases with support for 360mm fan mounts
• System builders seeking ARGB lighting synchronized with motherboard software
• Users wanting PWM speed control for quieter operation under light loads

Key specifications

• Form factor: three 120mm fans arranged for 360mm mounting
• Control: PWM fan speed control compatible with 4-pin PWM headers
• Lighting: addressable RGB (ARGB) per-fan illumination compatible with ARGB controllers
• Color: black fan frames and blades
• Connector types: standard PWM power connector and ARGB signal connector (compatible with typical 3-pin ARGB headers)

How to use

Install the three fans on a compatible 360mm radiator or in the case’s 360mm fan mounting position using the supplied mounting screws. Connect each fan’s 4-pin PWM power connector to motherboard or fan hub PWM headers to allow automatic speed control. Connect the ARGB signal cables to a compatible 3-pin 5V ARGB header or an ARGB controller to enable addressable lighting and synchronization with system lighting software. After physical installation, configure fan curves and ARGB effects in the motherboard BIOS or lighting control software as required.

Recommendations

Place the fans to create a consistent airflow path through the radiator (typically front-to-back or bottom-to-top) and configure PWM curves to balance cooling performance and noise. Ensure ARGB header compatibility (5V, 3-pin) before connecting to avoid signal mismatch. Periodically check mounting screws and cable routing to maintain optimal airflow and prevent vibration.