Switch PoE industriale DAHUA CHS4206-4ET-90 4 porte PoE

DAHUA Industrial PoE Switch CHS4206-4ET-90 is a 4-port PoE Ethernet switch built for industrial network deployments. It delivers data and power over a single cable to connected devices, enabling simplified installation of IP cameras, wireless access points and other PoE-capable equipment. The switch is designed for continuous operation in demanding environments and supports standard Ethernet connectivity and PoE power delivery suitable for surveillance and edge networking scenarios.

Advantages

The switch integrates four PoE-enabled Ethernet ports that reduce cabling and deployment time by carrying both data and power over the same cable. Its industrial design offers enhanced durability and stable performance in harsher conditions compared with consumer-grade switches. The device provides straightforward connectivity for networked devices at the edge, supporting common surveillance and access point power requirements and helping to centralize power management for small-scale installations.

Suitable for

• Outdoor or indoor surveillance systems with PoE IP cameras
• Wireless access point deployments where power over Ethernet is needed
• Small industrial or edge network sites requiring compact PoE switching
• Temporary or permanent installations where simplified cabling is preferred

Key specifications

• Number of PoE ports: 4 PoE-enabled Ethernet ports
• Port type: 10/100/1000 Mbps Ethernet (auto-negotiation)
• Power over Ethernet: Supports delivering power to connected PoE devices over Ethernet cabling
• Installation profile: Designed for industrial and edge environments with robust operation expectations
• Form factor: Compact switch suitable for rack, DIN-rail or wall mounting in constrained spaces

How to use

Install the switch according to site requirements and mount it in a protected area suitable for industrial equipment. Connect the switch to a network uplink using a standard Ethernet cable and plug PoE-powered devices into the PoE-enabled ports. Verify power and link indicators to confirm successful connections. Configure connected devices through their management interfaces as required; the switch supplies power and basic Layer 2 connectivity without additional configuration on plug-and-play models.

Recommendations

Use Category-rated Ethernet cables (Cat5e or higher) for reliable data and power delivery. Place the switch in a ventilated, dry location within the operating temperature range of the device, and plan power budgets to ensure connected PoE devices do not exceed the switch’s total available power. For extended or mission-critical deployments, integrate surge protection and follow local grounding practices.