Transceiver SFP rame BlueOptics 1G-SFP-000190-BO 1250 Mbit/s argento

The BlueOptics Copper SFP Transceiver 1G-SFP-000190-BO is a compact copper SFP module designed for 1.25 Gigabit Ethernet links. With a maximum data transfer rate of 1250 Mbit/s and a single RJ-45 port, the module supports standard copper network connections up to 100 m. Its SFP form factor and lightweight silver housing make it suitable for integration into switches, routers and media converters that accept SFP copper modules.

Advantages

The transceiver offers a compact SFP form factor that saves space in dense rack installations while maintaining a straightforward RJ-45 copper interface. A rated MTBF of approximately 1,000,000 hours indicates long operational life under normal conditions. The device’s modest weight and industry-standard connector ensure easy installation and replacement without special tools.

Suitable for

• Short-range copper Ethernet connections in data centers and wiring closets
• Upgrading SFP-capable switches and routers to support 1.25 Gigabit copper links
• Integration with media converters and network appliances that accept SFP modules
• Temporary or permanent links where fiber is not available or necessary

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Ethernet interface: 1.25 Gigabit Ethernet via RJ-45
• Number of RJ-45 ports: 1
• Maximum transfer distance over copper: 100 m
• Form factor: SFP (Small Form-factor Pluggable)
• Weight: 0.02 kg
• Product colour: Silver
• Reliability: Mean time between failures (MTBF) ~1,000,000 hours

How to use

Insert the BlueOptics SFP copper transceiver into an available SFP slot on a compatible switch, router or media converter until it clicks into place. Connect a standard Cat5e/Cat6 Ethernet cable to the RJ-45 port on the transceiver and to the remote device. Ensure both ends of the link support the intended data rate and verify link status via the network equipment’s indicators or management interface. For safe removal, power down or follow hot-swap procedures recommended by the host device and gently withdraw the module using the built-in release mechanism.

Recommendations

Use quality shielded or unshielded copper Ethernet cables appropriate for the required throughput and keep cable runs within the specified 100 m limit. Verify compatibility with the host device firmware and consult device documentation for supported SFP modules to ensure reliable operation.