Ventola per case 120 mm confezione da 4 HYTE FA12 nero, supporto PWM, montaggio standard 120 mm

Set of four HYTE FA12-BB-4 120 mm PC cooling fans designed to provide case airflow and support CPU/GPU ventilation. Each fan measures 120 x 25 mm, runs up to 1500 RPM, and delivers an airflow of 72 m³/h with a maximum static pressure of 1.6 mmH2O. The fans use a Fluid Dynamic Bearing (FDB) for reduced noise and improved longevity. Black finish and standard 120 mm size make the set suitable for intake, exhaust, or installation on radiators where compatible.

Advantages

The HYTE FA12-BB-4 pack combines a hybrid fan blade geometry and a balanced performance profile that offers both useful airflow and moderate static pressure, useful for general case ventilation and some radiator or heatsink use. Fluid Dynamic Bearings reduce operational noise and extend service life compared with sleeve bearings. Braided sleeved PWM cables provide cleaner cable routing and allow precise speed control across the supported RPM range. Integrated vibration isolators reduce transfer of vibration to the case, helping to minimise unwanted noise.

Suitable for

• Case intake and exhaust fans in mid-tower and full-tower PC cases
• Mounting on air coolers or radiators where 120 mm fans are supported and moderate static pressure is sufficient
• System builds requiring matched aesthetics with black fans and tidy sleeved cables
• Replacing worn or noisy 120 mm fans in existing systems

Key specifications

• Fan diameter: 120 mm
• Dimensions: 120 x 25 x 120 mm
• Quantity: 4 fans per pack
• Maximum rotational speed: 1500 RPM
• Airflow: 72 m³/h
• Maximum static pressure: 1.6 mmH2O
• Bearing type: Fluid Dynamic Bearing (FDB)
• Cable: Braided sleeved PWM cable for speed control
• Colour: Black
• Vibration reduction: Integrated vibration isolators

How to use

Install the fans into compatible 120 mm mounting locations in your PC case or on a supported radiator or heatsink. Secure each fan with the appropriate screws, align the airflow direction according to your case cooling plan, and connect the PWM cable to a motherboard fan header or a compatible fan controller. Configure fan curves in the system BIOS or software to balance cooling performance and noise according to your needs. Ensure cables are routed to avoid contact with fan blades.

Recommendations

For balanced performance, use these fans as matched intake and exhaust units to establish consistent airflow pathways. When mounting on radiators, place the fans in the orientation that supports your desired push or pull configuration and monitor system temperatures after setup. Clean the fans periodically to maintain airflow and bearing performance; avoid lubricants not specified by the manufacturer.