Modulo in fibra ottica CBO 320-2879 1250 Mbit/s 1310 nm monomodale

The CBO fiber optic module 320-2879 1250 Mbit/s 1310 nm single-mode is a compact transceiver designed for single-mode fiber networks. It supports a 1250 Mbit/s data rate at a 1310 nm wavelength and is intended for telecom and data communication links that require stable single-mode transmission. The module is suitable for uplink connections, metro aggregation links and point-to-point long-distance segments where consistent optical performance is needed.

Advantages

This BlueOptics transceiver offers a compact form factor and straightforward integration into SFP-compatible network equipment. It provides reliable single-mode transmission at 1310 nm with support for 1250 Mbit/s throughput. The module minimizes footprint in dense rack environments while maintaining electrical and optical interfaces that match standard networking ports, facilitating easy replacement or upgrades without major system changes.

Suitable for

• Uplink ports between switches and routers
• Metro and access network aggregation links
• Point-to-point long-distance single-mode connections
• Replacement or spare transceiver inventory for telecom equipment

Key specifications

• Optical mode: single-mode fiber
• Wavelength: 1310 nm
• Data rate: 1250 Mbit/s
• Form factor: compact SFP-compatible transceiver
• Application: telecom and data communications links

How to use

Install the module into any compatible SFP slot following the host device manufacturer’s instructions. Ensure the fiber cable is single-mode and terminated with connectors matching the equipment ports. Observe correct handling of the optical port to avoid contamination: cap the transmitter and receiver when not in use and clean connector end faces before insertion. After physical installation, verify link status and configure network settings on the connected devices as required.

Recommendations

For optimal performance, use single-mode fiber with appropriate attenuation and distance planning for 1310 nm transmission, monitor link quality after installation, and keep spare caps on connectors to protect optical surfaces when the module is not connected.