Ricetrasmettitore CBO ABCU-5730GZ cavo in rame 10Gbps

The Transceiver CBO ABCU-5730GZ Copper Wire 10Gbps is a 10 Gigabit Ethernet copper transceiver engineered for short-reach links over existing copper cabling. Designed to provide a standardized electrical interface for network devices, this module supports 10Gbps data rates and is intended for server-to-switch and switch-to-switch connections within data centers and enterprise networks. Its compact form factor and compatibility with 10GbE ports make it suitable for environments that require low-latency, high-throughput connectivity without the need to replace copper infrastructure.

Advantages

This copper transceiver offers 10Gbps throughput with low latency and predictable performance on short-reach copper links. It enables reuse of installed copper cabling, reducing upgrade costs compared with fiber deployments while maintaining adequate bandwidth for bandwidth-sensitive applications. The module provides a standardized plug-in interface for compatible network equipment, simplifying installation and replacement. Its design focuses on interoperability and reliable electrical signal transmission for typical data center and enterprise topologies.

Suitable for

• Server-to-switch connections in rack and row deployments
• Switch-to-switch aggregation and uplink links within the same equipment room
• Edge and access layer 10GbE upgrades where copper runs are under 10 meters
• Environments seeking cost-effective short-reach high-speed links over existing copper cabling

Key specifications

• Data rate: 10 Gbps
• Medium: Copper twisted-pair cabling
• Reach: short-reach links (typical support for up to several meters depending on cable and environment)
• Interface: 10 Gigabit Ethernet electrical transceiver form factor
• Use case: server-to-switch and switch-to-switch connectivity

How to use

Insert the transceiver into a compatible 10GbE module slot on the host switch or network device according to the equipment vendor’s installation procedure. Connect the copper cable between devices using appropriate twisted-pair cabling and ensure cable terminations meet category and distance requirements for 10GbE. Verify link status and speed via the host device management interface and monitor for errors during initial operation. For best results, follow the network equipment manufacturer’s recommendations for module compatibility and firmware versions.

Recommendations

Use high-quality, certified twisted-pair copper cabling and keep cable runs within the supported short-reach distance to maintain signal integrity. Confirm compatibility with the host device and test link performance after installation. In high-interference environments, consider routing and shielding practices to reduce crosstalk and electromagnetic interference.