Cavo di rete LogiLink 10 m Cat.6 RJ-45 S/FTP giallo

LogiLink Networking Cable Cat.6 S/FTP PIMF, 10 m, yellow, with RJ-45 connectors on both ends. This shielded Cat.6 patch cable uses S/FTP (overall braid with individually foil‑shielded pairs) construction and bare copper conductors to ensure stable high‑speed data transmission for home and office networks. The LSZH (low smoke zero halogen) jacket reduces hazardous fumes in case of fire and the cable meets ISO/IEC 11801, EN50288 and TIA/EIA 568‑B.2‑1 standards.

Advantages

The S/FTP PIMF design provides improved protection against electromagnetic interference and crosstalk compared with unshielded cables. Bare copper conductors and AWG 27/7 stranded construction offer reliable conductivity and flexibility for typical patching scenarios. The 10 m length gives flexibility in device placement while the yellow LSZH jacket allows for easy identification and safer operation in enclosed spaces.

Suitable for

• Connecting routers, switches and desktop computers
• Patching between wall outlets and network equipment in office or home environments
• Structured cabling segments requiring Cat.6 performance and shielding

Key specifications

• Category: Cat.6
• Shielding: S/FTP (overall braid + individually foil‑shielded pairs), PIMF
• Conductor: bare copper, AWG 27/7
• Connectors: RJ-45 to RJ-45
• Length: 10 m
• Jacket: LSZH (low smoke zero halogen)
• Weight: 0.31 kg
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568‑B.2‑1
• Color: Yellow

How to use

Plug one RJ‑45 connector into the network port of a router, switch or computer and the other end into the corresponding port or wall outlet. Ensure connectors are fully inserted and that cable routing avoids sharp bends and sources of strong electromagnetic interference to maintain signal integrity. For patch panel installations, verify port numbering before connecting.

Recommendations

For best performance, use this Cat.6 S/FTP cable in shielded or mixed environments where reduced interference is required; avoid running the cable parallel to high‑power electrical lines and maintain bend radius recommendations from the manufacturer.