Cavo in fibra ottica InfiniBand BlueOptics UACC-AOC-SFP28-7M-BO 7 m SFP28 maschio

The BlueOptics UACC-AOC-SFP28-7M-BO InfiniBand fibre optic cable is a 7-meter active optical cable (AOC) with SFP28 male connectors on both ends. Designed for 25G high-speed links, this multi-mode fibre assembly integrates transmitters and receivers in each connector to carry optical signals according to SFP28 / 25GBASE-SR4-compatible interfaces. Its aqua jacket provides clear identification in data center environments while the single-piece AOC design eliminates separate transceivers and simplifies short-reach connections between compatible Ethernet, InfiniBand or storage networking equipment.

Advantages

The cable provides low-latency, high-bandwidth connectivity for short-reach interconnects and supports up to 25 Gbit/s per lane as implemented in SFP28/25GBASE-SR4 profiles. Active optics reduce electrical power and heat compared with copper DACs at similar speeds over equivalent distances. The integrated transmitter/receiver modules and standardized SFP28 form factor enable plug-and-play replacement in systems that accept SFP28 AOC modules. Durable multi-mode fibre and a flexible jacket ensure reliable performance in rack-to-rack and chassis-to-chassis cabling.

Suitable for

Key specifications

How to use

Insert each SFP28 connector into the corresponding SFP28 port on compatible networking or storage devices until the latch engages. Ensure the host devices officially support SFP28 AOC modules of this type and that ports are powered down or follow hot-swap procedures recommended by the equipment vendor when installing. After insertion, verify link status on both ends and configure interface parameters on the devices as required by your network or storage setup.

Recommendations

Use this cable for short data center interconnects where 25G performance and low latency are required. Avoid tight bends in the cable; maintain manufacturer-recommended bend radius for multi-mode fibre. Confirm compatibility with the specific switch, router or storage platform before deployment and test links after installation.