Cavo patch ACT grigio 1 metro U/UTP CAT6A con connettori RJ45

The ACT Grey 1 meter U/UTP CAT6A RJ45 patch cable is a 1 m network lead designed to support high-speed data transmission in structured copper networks. It features gold-plated RJ45 connectors for improved contact and reduced signal loss. The cable is constructed with full copper conductors and meets CAT6A performance requirements and ANSI/TIA568-C2-1 recommendations, providing stable throughput for typical LAN and PoE installations. The U/UTP design provides basic protection against electromagnetic interference while maintaining a compact, flexible jacket in a neutral grey finish.

Advantages

This patch cable uses full copper conductors, which are required for reliable Power over Ethernet delivery and consistent signal integrity. Gold-plated RJ45 plugs improve contact reliability and reduce corrosion risk. Compliance with CAT6A performance standards and industry wiring recommendations ensures compatibility with existing structured cabling and network equipment. The 1 meter length reduces excess cabling in patch panels and desk connections, helping maintain an orderly installation.

Suitable for

• Short horizontal patching between wall outlets, switches and patch panels
• Desktop connections for computers, IP phones and access points
• Power over Ethernet (PoE) devices requiring full copper conductors
• Network test setups and temporary cabling where 1 m length is sufficient

Key specifications

• Cable category: CAT6A (augmented)
• Shielding: U/UTP (unshielded overall, twisted pairs unshielded)
• Length: 1 meter
• Conductor: solid full copper conductors
• Connector type: RJ45 with gold-plated contacts
• Construction: 4 twisted pairs, structured for LAN performance
• Safety class: CPR Euroclass Eca

How to use

Connect one RJ45 plug to a network port on a switch, router or wall socket and the other plug to the device requiring network access. Ensure connectors are fully inserted until the latch engages to guarantee proper contact. Use the 1 m length for close equipment connections to avoid cable slack; for longer runs, deploy appropriate permanent cabling and use patch leads only for final interconnects. When using PoE devices, verify that both the switch and device support the required power class.

Recommendations

Install the cable without sharp bends and avoid running it alongside high-voltage power lines to minimize interference. For rack or patch panel installations, label each end for easy identification. Replace any cable that shows visible damage to the jacket or connectors to maintain reliable network performance.