Cavo patch DIGITUS CAT6 U-UTP sottile, 1 m, giallo, confezione da 10

DIGITUS CAT6 U-UTP Slim, 1 m, yellow, pack of 10 are slim unshielded patch cables designed for Gigabit Ethernet networks. Each pack contains ten 1-meter U-UTP patch cords with a reduced outer diameter and flexible jacket, intended to save space in patch panels, cable management channels and other high-density cabling environments. The cables are constructed with stranded AWG 32/7 bare copper conductors, HD-PE insulation and RJ45 plugs with molded anti-kink sleeves and strain relief. They comply with CAT6 performance requirements and relevant international cabling standards.

Advantages

The slim 2.7 mm outer diameter and flexible jacket allow neat routing in confined spaces and behind equipment while preserving CAT6 transmission characteristics up to 250 MHz and supporting Gigabit Ethernet speeds. Molded strain relief and locking lever protection reduce the risk of connector damage and locking breaks. LSZH outer casing and compliance with recognized standards provide predictable behavior in professional and residential installations.

Suitable for

• Connecting switches, routers and patch panels in office networks
• Home networking and multimedia devices
• High-density cabling racks and cable management channels
• Structured cabling in data closets and telecom rooms

Key specifications

• Cable category: CAT6 U-UTP (unshielded twisted pair)
• Length: 1 m
• Pack contents: 10 pieces
• Outer diameter: 2.7 mm ± 0.15 mm
• Conductor: stranded bare copper AWG 32/7 (0.08 ± 0.005 mm)
• Insulation: HD-PE (high-density polyethylene)
• Jacket material: LSZH (Low Smoke Zero Halogen)
• Frequency rating: up to 250 MHz
• Data rate: up to 1 Gbit/s (1000BASE-T)
• Plug type: RJ45 with molded anti-kink sleeve and strain relief
• Bending radius: 15 × outer diameter
• Operating temperature: -20 °C to +60 °C
• Flame retardancy and smoke tests: IEC 60332-1, IEC 61034
• Typical Ethernet applications: 10BASE-T, 100BASE-T, 1000BASE-T
• Service life: 750 mating cycles

How to use

Install the DIGITUS CAT6 U-UTP Slim patch cables by inserting the RJ45 plug into the corresponding port on switches, routers, patch panels or network devices until the locking tab engages. Route the slim cable through cable management channels or behind equipment, observing the minimum bending radius to avoid excessive stress. For PoE and PoE+ powered devices, ensure connectors and equipment support the required power levels; the cables use pure copper conductors suitable for PoE applications.

Recommendations

Maintain the specified bending radius and avoid sharp kinks; label or color-code connections in patch panels to simplify maintenance. Use these slim cables where space savings and flexibility are required, and verify that overall link length and network equipment support Gigabit Ethernet performance.