Cavo patch ROLINE S/FTP (PiMF) Cat.6 bianco 20 m

Patch Cord ROLINE S/FTP (PiMF) Cat.6 White 20 m is a 20-meter Category 6 network patch cable with S/FTP (PiMF) shielding and screened RJ-45 connectors on both ends. The cable is constructed from four pairs of stranded copper wire with pair-level aluminium-clad polyester foil and a complete braided shield to reduce electromagnetic interference. Connectors use gold-plated contacts and moulded kink protection for increased durability while the white, flexible jacket allows routing in confined spaces.

Advantages

The S/FTP (PiMF) shielding provides effective protection against crosstalk and external interference, supporting reliable high-speed data transmission. Gold-plated contacts ensure long-lasting contact quality and corrosion resistance. The moulded kink protection and flexible cable jacket improve mechanical durability and make the cable suitable for installations with tight bends. Contact wiring follows the EIA/TIA 568 1:1 standard for straightforward plug-and-play connectivity.

Suitable for

• Office and data center patching between switches, routers and patch panels
• Connecting PCs, printers and networked devices to structured cabling
• Environments requiring reduced electromagnetic interference (S/FTP shielding)
• Installations where a 20 m white cable is preferred for routing and aesthetics

Key specifications

• Length: 20 m
• Category: Cat.6
• Shielding: S/FTP (PiMF) — pair-shielded with overall braid
• Conductor: 4-pair stranded copper
• Connectors: RJ-45 to RJ-45, gold-plated contacts, 1:1 EIA/TIA 568 wiring
• Colour: White

How to use

Connect one RJ-45 plug to the network port of your switch, router or patch panel and the other plug to the target device. Ensure connectors are fully inserted until the latch clicks. Avoid excessive bending beyond the cable’s minimum bend radius and do not pull on the connector body; route the cable along cable management paths to reduce mechanical stress.

Recommendations

For optimal performance, use this Cat.6 S/FTP patch cord within typical Ethernet standards and environments free of severe mechanical damage. Keep the cable away from high-power electrical cables where possible and avoid repeated sharp bends; for permanent horizontal runs consider using fixed installation rated cables.