IVT set di cavi 2 m 25 mm² per inverter SW Series 1200 W

IVT cable set 2 m 25 mm² for SW Series inverter 1200 W is a ready-made power connection cable intended for short, heavy‑duty interconnections between the SW Series 1200 W inverter and batteries or nearby distribution points. The set contains two meters of 25 mm² conductors sized to carry the current required by a 1200 W inverter, providing a compact solution for installations where a short, low‑loss connection is needed.

Advantages

The cable set offers a standardized length and conductor cross‑section that reduce voltage drop and heat buildup in the connection. Preassembled terminations and consistent conductor sizing simplify installation and help ensure safe, repeatable connections. The 25 mm² cross‑section provides sufficient current capacity for the specified inverter power while keeping the cable bundle manageable in confined spaces.

Suitable for

Key specifications

How to use

Route the cable set from the inverter to the battery or distribution point, keeping the run as short and direct as practical to minimize voltage drop. Ensure both ends are securely attached to the inverter and battery terminals or to appropriate distribution blocks, observing correct polarity. Use properly rated terminals, lugs or connectors and tighten to manufacturer torque recommendations. Protect the cable from abrasion, sharp edges and heat sources, and avoid tight bends near the terminations.

Recommendations

Verify compatibility with the specific SW Series inverter model and follow all safety guidelines for DC power connections: disconnect sources before working, fuse or circuit‑protect the positive lead according to system requirements, and periodically inspect terminations and insulation for wear or corrosion.