Modulo ricetrasmettitore di rete CBO BlueOptics MFM1T02A-LR 10.000 Mbit/s 1310 nm

The CBO BlueOptics MFM1T02A-LR 10,000 Mbit/s 1310 nm is a single-mode fiber-optic transceiver module designed for 10 Gb/s links. It supports a nominal wavelength of 1310 nm and is intended for use in network switches, routers and fiber-optic transceivers that accept compatible modules. The module enables long-reach connections over single-mode fiber, offering a straightforward upgrade path for data center uplinks and enterprise backbone links while preserving line-rate throughput.

Advantages

This transceiver provides stable 10,000 Mbit/s transmission over single-mode fiber at 1310 nm, delivering predictable signal quality and low-latency data transfer. Its form factor and electrical interface are compatible with common network equipment, allowing easy replacement or upgrade of existing ports without extensive reconfiguration. The module is engineered for reliable optical performance across typical operating conditions and helps extend link distance compared with multimode solutions.

Suitable for

Key specifications

How to use

Install the module into a compatible transceiver slot on your switch or router following the device manufacturer’s hot-plug guidance. Connect the single-mode fiber patch cable with appropriate LC/SC connectors (as required by the host equipment) and ensure fiber polarity and end-face cleanliness before powering the link. Monitor link status via the host device interface and verify signal levels and error counters after installation to confirm reliable operation.

Recommendations

Maintain clean fiber end-faces and use approved single-mode patch cables to ensure optimal optical performance. Verify compatibility with your switch or router and consult the host equipment documentation for supported transceiver types and any required firmware or configuration settings.