Modulo ricetrasmettitore SFP+ BlueOptics 407-BCZQ-BO 10000 Mbit/s

The BlueOptics 407-BCZQ-BO SFP+ transceiver module provides a compact, industry-standard interface for high-speed fiber optic links. Designed for SFP+ slots, this module supports a maximum data transfer rate of 10000 Mbit/s and is intended for single-mode fiber connections with LC duplex connectors. The module is silver in colour, weighs approximately 20 g (0.02 kg) and has a long mean time between failures (MTBF) rating of 1,000,000 hours. It follows MSA-compatible form factor conventions for interoperability with a wide range of networking hardware.

Advantages

The transceiver offers a standardized SFP+ form factor that enables easy installation and hot-swapping in compatible equipment. With support for 10 Gbit/s links, compact dimensions and low weight, it is suitable for dense deployments where space and power are constrained. The high MTBF rating indicates long-term reliability for continuous network operation.

Suitable for

• High-speed Ethernet uplinks and aggregation links up to 10 Gbit/s
• Connections over single-mode fiber using LC duplex connectors
• Integration into SFP+-equipped switches, routers and storage systems that accept MSA-compatible modules
• Network environments requiring compact transceivers with low weight and standardized interfaces

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: SFP+ (MSA-compatible)
• Connector type: LC duplex (for single-mode fiber)
• Typical application: 10GBASE-LR optical transmission over single-mode fiber
• Colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours

How to use

Install the BlueOptics 407-BCZQ-BO into an empty SFP+ slot on the target device according to the host equipment manufacturer’s instructions. Connect LC duplex single-mode fiber cables to the module ensuring correct orientation of transmit and receive fibers. After physical installation, verify link status and any required port settings on the switch, router or storage appliance. The module is intended to be hot-pluggable in systems that support hot-swap of SFP+ transceivers.

Recommendations

Ensure the host device officially supports MSA-compatible SFP+ modules and configure port speed and duplex according to network design. Use appropriate single-mode fiber and clean LC connectors before insertion. Avoid mechanical stress on the module and fiber cables; observe manufacturer guidelines for insertion/removal and ESD precautions.