Modulo ricetrasmettitore SFP BlueOptics AFBR-5710LZ-BC-BO 550 m

The BlueOptics AFBR-5710LZ-BC-BO SFP transceiver module is a compact fiber-optic module designed for 1.25 Gbps multimode links with a maximum reach of up to 550 meters. Housed in an aluminium casing and weighing approximately 20 grams, this SFP module provides a standard LC duplex interface and follows MSA form-factor requirements for straightforward installation in compatible switch, router or storage ports. It implements 850 nm transmit and receive optics suitable for 1000Base-SX applications and supports digital diagnostic monitoring when the host hardware exposes DDM/DOM features.

Advantages

The module provides compatibility with common Broadcom-based platforms and adheres to MSA standards, enabling plug-and-play replacement or expansion of existing multimode fiber links. Its aluminium housing offers mechanical durability and thermal conduction, while the lightweight design simplifies handling during installation. Built to industry component selection practices, the transceiver supports long operational lifetime and reduced maintenance needs.

Suitable for

• Short- to mid-range multimode Ethernet links (up to 550 m)
• Switch and router SFP ports in enterprise and data center environments
• Storage systems and network appliances supporting 1000Base-SX
• Environments requiring DDM/DOM-capable optical monitoring

Key specifications

• Interface type: SFP (MSA-compliant form factor)
• Data rate: up to 1.25 Gbps (1000Base-SX)
• Optical wavelength: 850 nm (transmit and receive)
• Maximum transmission distance: up to 550 meters over multimode fiber
• Connector: LC duplex
• Housing material and colour: aluminium
• Weight: approximately 0.02 kg
• Supports Digital Diagnostic Monitoring (DDM/DOM) when supported by host hardware

How to use

Power down or follow hot-swap procedures for your equipment according to the device manufacturer before inserting the SFP. Remove protective caps from the transceiver and from the LC connectors on the fiber patch cords, then insert the BlueOptics SFP into an empty SFP slot until it latches. Connect LC duplex multimode patch cords to the module, ensuring correct transmit/receive orientation. Verify link status and, if available, read DDM/DOM parameters from the host interface to confirm optics health and operating values.

Recommendations

Use multimode fiber (OM1/OM2/OM3 as appropriate) and quality LC duplex patch cords to reach the specified 550 m range. Ensure the host hardware officially supports compatible 1000Base-SX SFP modules and that firmware or driver settings do not block third-party transceivers. Keep dust caps on when not in use and avoid bending fiber beyond recommended radii to maintain signal quality.