Modulo ricetrasmettitore SFP BlueOptics SFP-4-CM-BO 155 Mbit/s 1310 nm

The BlueOptics SFP-4-CM-BO 155 Mbit/s 1310 nm is a single-mode fiber SFP transceiver module designed for use in network media converters and compatible ComNet platforms. It supports a maximum data transfer rate of 155 Mbit/s over distances up to 40 km using an LC duplex connector and operates at a wavelength of 1310 nm. The module is compact and lightweight (approximately 20 g) and is manufactured to MSA standards to ensure physical and electrical compatibility with SFP ports in switches, routers, storage systems and other network devices that accept ComNet-compatible 100BASE-LH modules.

Advantages

This transceiver offers reliable optical transmission with support for 155 Mbit/s on single-mode fiber over long distances. Built to industry MSA standards, the module provides plug-and-play interoperability with devices that support the ComNet 100BASE-LH form factor and LC duplex interfaces. The product includes components selected for longevity and stability, and the manufacturer states a long mean time between failures to support continuous operation in critical network links. The small form factor and silver housing make it suitable for dense installations and standardized rack or chassis equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-4-CM-BO into a compatible SFP slot of a switch, router, media converter or other network device that supports ComNet-compatible 100BASE-LH SFP transceivers. Connect a single-mode LC duplex fiber patch cable to the module, ensuring correct transmitter/receiver orientation. Configure the network device according to its manual to enable the optical port and set any required link parameters. If the host device supports digital diagnostic monitoring (DDM/DOM), enable and monitor available diagnostics such as optical output power, received power, temperature and supply voltage for ongoing link health checks.

Recommendations

Use single-mode LC duplex patch cords and, where possible, route fibers through appropriate patch panels or protected troughs to maintain connector and fiber cleanliness. Verify host device compatibility with ComNet-compatible 100BASE-LH SFP modules and, if digital diagnostics are required, ensure the device firmware supports DDM/DOM. For best performance, follow standard fiber installation practices: clean connectors before mating, avoid tight bends, and verify link quality with suitable test equipment after installation.