Ricetrasmettitore SFP BlueOptics SFP-10G-LRM-DE-BO 10000 Mbit/s 1310 nm argento

The BlueOptics SFP-10G-LRM-DE-BO is a 10G SFP+ fiber optic transceiver designed for multi-mode fiber links. It supports data rates up to 10000 Mbit/s and operates at a wavelength of 1310 nm. Encased in a silver metal housing, the module uses an LC duplex connector and requires a 3.3 V supply while weighing approximately 3 g. The module implements 10GBASE-LRM optical signalling over multimode fiber and is compatible with systems that accept MSA-compliant SFP+ transceivers.

Advantages

This SFP+ transceiver provides a compact metal design that supports high-speed 10G transmission with low power consumption and a lightweight form factor. Built to MSA standards, the module offers broad compatibility with network equipment that supports SFP+ 10GBASE-LRM optics. The 1310 nm transmitter and receiver pair is suitable for multimode fiber runs and includes support for digital diagnostics monitoring where supported by host hardware.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-10G-LRM-DE-BO into an available SFP+ slot on a compatible switch, router or storage device following the host vendor's hot-swap and handling procedures. Connect LC duplex multimode fiber patch cords to the transceiver, observing correct TX/RX orientation. Verify link light and host interface configuration; enable any required port settings such as speed and duplex. If the host supports Digital Diagnostics Monitoring (DDM/DOM), enable and read diagnostic parameters through the device management interface to monitor supply voltage, temperature, transmit power and receive power.

Recommendations

Use industry-standard multimode fiber patch cords and, where possible, test the link after installation to confirm performance across the intended distance. Ensure the host hardware officially supports 10GBASE-LRM optics and the DDM/DOM feature if remote diagnostics are required. Handle the module by the edges, keep dust caps on unused ports, and follow ESD precautions during installation.