Ventola Arctic P14 Pro A-RGB 140 mm 400-2500 RPM nero

ARCTIC P14 Pro A-RGB 140 mm A-RGB PWM Fan with Cable Splitter, Fan, 14 cm, 400 RPM, 2500 RPM, 186 m³/h, Black

Efficient Performance at High Air Resistance

Thanks to high static pressure, the Pro fans move air effectively through tight spaces. This makes them ideal for radiators, perforated panels, and mesh filters.

Maximum Performance, Redefined

Revised fan blade design for an optimal balance of performance and smooth operation.

Optimized Bearing-Shaft Design (FDB)

A hydrodynamic bearing combined with an extended shaft ensures quieter operation by improving pressure distribution and minimizing vibrations.

Automated Two-Plane Balancing

An automated two-level measuring and balancing process ensures exceptional precision and smooth performance by applying the balancing mass with pinpoint accuracy at two different depth levels.

SOTA Microcontroller

Reduces motor noise, compensates for load fluctuations, and protects against inrush currents and reverse polarity.

More Power – Less Noise

The fan delivers more performance at low speeds with higher airflow and static pressure at just 25 dB(A) – ideal for quiet, powerful cooling.

Minimum Gap Dimensions for Maximum Efficiency

Enables higher static pressure and maximum airflow efficiency.

PST – PWM-Based Synchronized Fan Control

An additional PWM connector allows multiple fans to be synchronized in series using a single header.

How to use

Install the fan inside a computer case using the four mounting holes, aligning airflow direction as needed for intake or exhaust. Connect the fan to a compatible motherboard header or fan controller that supports PWM to enable automatic speed regulation. Ensure the fan has sufficient clearance and cable is routed to avoid contact with the blades. Clean periodically to maintain performance.

Recommendations

For optimal results, pair this 14 cm PWM fan with a motherboard or controller supporting PWM headers and place it in a position that complements your case airflow (intake at front/bottom, exhaust at rear/top). Regularly check for dust buildup and replace if bearing noise increases significantly.