Cavo DMX XLR 3 poli PSSO 5 m con connettori Neutrik

Balanced XLR 3-pin DMX cable PSSO 5 m with Neutrik connectors is a 5-metre professional signal cable designed for DMX lighting and stage control applications. The cable pairs a PSSO manufactured DMX cable with durable Neutrik XLR connectors to ensure stable data transmission between lighting controllers, dimmers and fixtures. Its balanced construction reduces interference and maintains signal integrity over a short to medium run, making it suitable for live events, installations and studio setups.

Advantages

The combination of a shielded, balanced cable and precision Neutrik connectors delivers reliable DMX512 signal transfer with low noise and secure mechanical connection. The 5 m length offers flexibility for typical stage and studio distances while keeping signal degradation minimal. Durable connector housings and strain relief increase longevity under frequent use and handling.

Suitable for

Key specifications

How to use

Connect the male and female Neutrik XLR connectors to the corresponding DMX output and input ports on your controller, dimmer or fixture. Ensure correct pin orientation (pin 1 = ground, pin 2 = data -, pin 3 = data +) and secure the connectors until the latch clicks to prevent accidental disconnection. Route the cable to avoid tight bends, sharp edges and heavy foot traffic; use cable ties or gaffer tape where appropriate to keep runs tidy and reduce mechanical stress.

Recommendations

For consistent DMX performance, keep runs as short as practical, avoid running alongside mains power cables, and verify termination at the end of the DMX chain if required. Inspect connectors and jacket periodically for wear, and replace the cable if inner insulation or shielding is compromised.