Cavo ottico attivo CBO SFP28 AOC BlueOptics BO272703Q30M 30 m

The Active Optical Cable CBO SFP28 BlueOptics BO272703Q30M is a 30-meter factory-terminated SFP28 AOC designed for direct connection between SFP28 ports in servers, switches and storage devices. This BlueOptics cable integrates active optical transceivers and a single multimode fiber link into a compact assembly, eliminating the need for separate transceiver modules and simplifying short-to-medium reach cabling in data centers and network racks.

Advantages

The cable reduces connector and module count by providing a pre-terminated optical link that supports high-speed 25/28 Gbps signaling over 30 meters. Because it uses optical fiber with active electronics, the assembly reduces port power consumption compared with equivalent copper direct-attach cables and minimizes electromagnetic interference. Factory termination ensures consistent performance and removes manual polishing or field termination requirements.

Suitable for

• Interconnecting 25G/28G SFP28 ports between switches and top-of-rack servers
• Short-to-medium reach links inside data center racks and between nearby racks
• High-density installations where transceiver slots and power budgets are limited

Key specifications

• Connector type: SFP28 plug-to-plug active optical assembly
• Length: 30 meters
• Data rate: supports 25 Gbps/28 Gbps class SFP28 interfaces
• Medium: optical fiber with active electronics for signal conversion
• Use case: direct-attach optical link for short-to-medium range interconnects

How to use

Install the Active Optical Cable by plugging each SFP28 connector into the corresponding SFP28 port on the network equipment. Ensure devices are powered off or follow hot-plug guidelines from the equipment vendor when inserting or removing connectors. Verify link status and configuration on both ends after insertion. No separate transceivers or field termination is required, as the cable is factory-terminated and ready for immediate use.

Recommendations

Route the cable to avoid tight bends and mechanical strain; follow the manufacturer’s minimum bend radius. Use cable management in racks to secure the assembly and prevent stress on the SFP28 connectors. Confirm device compatibility with SFP28 AOC links and check firmware or compatibility lists if necessary for optimal link stability.